|
Small Telemetry System with 2 channels, direct Sensor connection · 2 channels, 12 bit resolution, simultaneous sampling of all channels · Anti aliasing filters · Direct sensor connection for STG, Thermo couples K or high level inputs · +/- 5V analogue output at the receiver side, optional dig. output for PC interface · Distance up to 500m between transmitter and receiver · Static acceleration up to 100 g in all directions · Signal bandwidth 2 x 0-375Hz with 40kbit transmitter
CT2 Mini
Small Telemetry System with 2 channels, direct Sensor connection!
|
|
|
·
2 channels, 12 bit resolution, simultaneous sampling of all channels !
·
Direct sensor connection for STG, Thermo couples K, ICP or high level inputs !
·
+/- 5V analogue output at the receiver side, optional dig. output for PC interface !
·
Static acceleration up to 100 g in all directions ! |
·
Anti aliasing filters
·
Water protected encoder housing (IP65)
·
Distance up to 500m between transmitter and receiver (depends of antennas)
·
Signal bandwidth 2 x 0-375 Hz with 40kbit transmitter
|
|
|
Transmitter unit for 2 Channels
|
|
|
|
Receiving unit for 2 Channels with antenna
|
|
CT2 Mini - SET
|
|
CT2-Mini is an 2-channel telemetry system designed for easy mounting on to rotating and moving parts to provide non-contact transmission of measured parameters such as pressure, force, temperature, acceleration and voltage. Also for point to point application like bridge or buildings testing, you can install CT2 Mini instead long cables from the sensor to the Computer.
Sensors inputs are connected via screw on, waterproof connectors. Measured values are prepared in analog format, digitized and transmitted via radio frequencies. Four different carrier frequencies are provided, this allows up to four systems (e.g. for four wheels) to operate in parallel. The complete transmitter assembly is waterproofed to IP65 specifications.
The following sensors can be connected to the system: (STG) Strain gages sensors in full-, half- and quarter-bridge configuration (350 ohm or greater), Type K Thermocouples to 900°C, ICP and capacitive sensors. Voltage inputs of +/-5V and +/-10V are available.
The measured values are processed and output as +/-5V analog signals at the BNC sockets (optional digital output for special PCM interface into a PC) on the stationary receiver located in a vehicle or helicopter cabin.
Resolution of 12 bits is standard; this enables an amplitude dynamic of 72 dB. The analog signal bandwidth is 2 x 0-375 Hz. The measurement accuracy is +/-0.5 % (without sensor). The CT2-Mini is suited for operation at ambient temperatures of -20 to +70°C. The transmission distance between transmitter and receiving antenna is of the order of 250 m (10mW transmitting power) (750 feet) or up to 5km with optional power booster (250mW transmitting power) and special power antennas (polarization antenna +10dB on transmitting and receiving side).
|
|
